Receptor 9 Canais RadioLink R9DS DSSS AT9 AT10 2.4Ghz(43x24x15mm)

BUS and PWM signal change: Short

press ID SET switch twice within 1 second, the signal changes from normal PWM to SBUS. The red LED indicates normal PWM and the blue / purple LED indicates the SBUS signal.

How to pair the code with the transmitter:

1. Place the transmitter and receiver close to each other within 1 meter.
2. Turn on the transmitter, then turn on the R9DS.
3. Connect CH3 of R9DS to ESC.
4. There is a black button on the R9DS, use a thin stick press the button twice within two seconds and release, the receiver light starts flashing, after about 8 times flashing, phosphor code success when the signal receiver LED always on!


Installation of the receiving antenna:

1. The antenna should be kept as straight as possible. Otherwise it will reduce the effective range.

2.Large model aircraft can of some interference signal from the metal part; In this case the antennas must be placed on both sides of the model. Then the best RF signal condition is obtained in any flight attitude.

3. Antennas should be kept away from conductive materials, such as metal and carbon, at least one half inch. The coaxial part of the antennas does not need to follow these guidelines, but do not bend it in a small radius.

4. Keep the antennas away from the motor, ESC, and other noise sources as much as possible.

5.Press and hold the Easy Link (ID SET) one second, now the receiver starts working.

6. After finishing all the above steps, the LED indicator will turn and stay red.

7.The receiver can be packed by sponge or foam for shocking proof when it is installed to the model.

After finishing all the above steps, turn off the transmitter and then turn it on, now the program works to secure it under the control of the transmitter with a correct connection.



Technical parameters

1) Channels:
9 channels: output 9 channels of PWM signal, with red LED.
10 channels: 10 channel signal output, support SBUS and PWM signal output synchronously, with blue LED.

2) Working voltage: 4.8-10V

3) Working current: 38-45mA (input voltage: 5V)

4) Size: 43 * 24 * 15 mm

5) The receiver integrates the telemetry sensor including signal strength and voltage. Support prolonged motor voltage telemetry module PRM-01 and PRM-02 module can regenerate GPS information, speed, voltage etc. on AT9 / AT9S / AT10 display when working with APM or PIX flight controller.

6) 4096 frequency precision section, 0.25us per section, without shaking the servos of any kind.

7) MINI receiver, you only need one cable if you use the SBUS signal.