SAVÖX SB-2291SG SERVO
High end brushless HV tail servo
25kg actuating force @ 8.4V
0.042 sec/60° operating time @8.4V
Patented structure
3x ball bearings, brushless motor integrated into the housing


DESCRIPTION
WHAT DOES HV MEAN AT SAVÖX?

HV stands for high voltage. Savöx servos marked in this way can be operated with a voltage of up to 8.4V . The use of a 2s LiPo battery is possible without any problems. All HV servos can of course also be operated with a lower voltage from 4.8V, but less power is available here.



When the best is just good enough!


Are you looking for the ultimate performance for your tail rotor? Then from now on there is no way around the new Savöx SB-2291SG Brushless HV Monster tail servo! The patented design of the SB-229X Monster series has already been proven thousands of times in tough competitive use and delivers unsurpassed values ??in terms of operating time, operating force and, above all, longevity!

This is where the SB-2291SG comes in, the technical data speak for themselves! Previously unattainable actuating forces of 18kg and a positioning time of 0.05sec/60° at 7.4V give an idea that this is an absolute high-end tail servo from Savöx. The data at 8.4V i.e. a 2s LiPo is an incredible 25kg and 0.042sec/60°! So if you want to get the most out of your helicopter, there is now no way around this true monster! The servo software was brought to perfection in close collaboration with top pilots. This makes it possible to fly a wide range of head/tail speeds and always ensure optimal performance. Of course, the SB-2291SG can be operated on all known and proven gyros and flybarless systems.

The patented design with the motor integrated directly into the housing ensures optimal heat dissipation. The third ball bearing and the high-quality gear ensure that performance does not decrease even in tough competitive conditions. In combination with the well-known SB-2292SG servos on the swashplate, there are now no limits.

CHARACTERISTICS
Operating time S1/60° (sec): 0.05
Actuating force S1 (kg*cm): 18
Width (mm): 20.2
Actuating force S2 (kg*cm): 25
Height (mm): 38.7
Voltage range: 4.8V-8.4V
Length (mm): 40.3
Weight (g): 81
High-voltage capable up to 8.4V: Yes
Packaging: default
Recommended use: helicopter
Output teeth (number): 25
Ball bearings (number): 3
Voltage 1 (Volt): 7.4
Engine type: Brushless motor
Gear type: steel
Housing type: Full metal
Voltage 2 (Volts): 8.4
Classification: default